This Manrose rectangular vertical 90° bend is a ducting component used to route extraction ductwork from your cooker hood up and through tight spaces above kitchen cupboards. It connects to rigid rectangular ducting and changes the direction of airflow by a right angle, which is often needed where a duct run has to turn a corner behind or above cabinetry to reach an external wall or ceiling void.
Key
Benefits
- Fits above kitchen cupboards, so the ducting stays hidden and your extraction run doesn't interrupt the clean lines of your cabinetry.
- Uses female connections at both ends, making it straightforward to join into an existing rigid duct system without extra adaptors.
- White finish means it blends in if any section is ever visible, rather than standing out against light cabinetry or ceilings.
- Rigid rectangular design holds its shape over time, unlike flexible ducting which can sag or restrict airflow if not properly supported.
- Backed by a 3 year manufacturer's guarantee, so it's built to last for the life of your kitchen extraction system.
Performance figures show how the bend behaves under different airflow rates, which matters if your cooker hood is being specified to meet a particular extraction requirement. At lower airflow, such as 8 litres per second, pressure loss through the bend is minimal at 3.3Pa. As airflow increases, so does the resistance, rising to 253Pa at 61 litres per second. Your installer will factor this into the overall duct run to make sure your hood extracts effectively rather than working against unnecessary resistance.
Specifications
- Type: Adaptor (rectangular vertical 90° bend)
- Height: 95mm
- Width: 115mm
- Depth: 95mm
- Colour: White
- Manufacturer's Guarantee: 3 years
- Packaged Weight: 5kg
